Wheel Bearing

Bearing serve to rotate the wheel on the hub with less resistance. They transmit the force applied to rotate the wheel on the axle. On the rear axle bearing modules are often used. When replacing the part, the module is entirely replaced. On the front axle there are installed angular contacts, conical roller, or radial bearings. It depends on the car model. To install and dismantle the wheel bearing a special tool is required. Therefore, it will be necessary to go to the car repair shop if the bearing is faulty.

In course of time wheel bearings wear out. As the bearing wears out, the noise level increases. Especially loud noise is when cornering. Increased noise level when cornering to the left indicates a faulty on the right side. Sometimes a play can appear because of wear. This problem can be diagnosed. When you turn the wheel press once on the brake and once turn the wheels without brake. If the play occurs in the last case, the problem is with the bearing.

If there is a faulty, you need to replace the bearing. To repair it you need a special press to press a new bearing in. Do not try to replace the bearing by yourself using a sledgehammer. A defective bearing must be timely replaced as it is dangerous to drive with a faulty bearing. In our Internet shop you will find any spare parts you need for your car: wheel brake cylinder, master cylinder, steering knuckles, brake shoes, window lifters, headlights, air dryer, fuel and oil filters.

HOW TO DETECT MALFUNCTIONS OF THE WHEEL HUB BEARING KIT

Check the condition of the bearing when brake pads are replaced, regardless of the vehicle mileage. The state of this component may be checked in several ways. At a speed of 10 - 15 km/h, make a sharp left turn. If the extraneous noise is not heard anymore, it indicates a fault in the bearing of the left wheel. Then check the right wheel the same way. More thorough diagnostics requires special equipment.

You will need a lift or a jack. Lift the vehicle, start the engine, switch to the fourth gear, and increase the speed up to 80 km/h. Next, engage the clutch and disengage the gear, carefully listening to the sound the source of which will be located in one of the wheels. You may try another method. Swing the wheel on the suspended vehicle first vertically, and then horizontally. Presence of even small free play is an indication of malfunction in the bearing, or in the steering system. Next, you will have to simultaneously press the brake pedal, and swing the wheel vertically (you will need an assistant). If the free play disappears, the component is to be replaced.