Engine Block

The crankcase is made of the engine casing, the cylinders and the cooling jacket. The crankshaft is situated inside this part. Sometimes the entire engine block is called a crankcase. In general, the crankcase is produced from iron or aluminum. In rare cases, it is also use a spheroidal graphite cast iron, if the stress of the material is particularly high. Sometimes, welding steel structures are possible, especially for very large motors. The crankcase has a cooling function, because it removes the heat generated during combustion and forwards it outside.

In addition, the crankcase must be very stable, because it must endure the forces which is generated during combustion. The cylinder tubes, in which the pistons are located, are taken from the crankcase. The mechanical stress that occurs during movement of the cylinders is enormous, so that the case must be appropriately dimensioned. A complete loss of the crankcase happens in very rare situation. The exchange of this part is very expansive, because it is necessary to dismantled almost the entire engine. Usually, you need to replace only the gasket.

The installation of a new crankcase is a work that should be taken over by an automotive shop. A small mistake during installation process can lead to further defects. In addition, it is necessary to move large weights, so the car owner does not have necessary conditions for repairing. If you also need a belt, a belt cover, a protective tube, one side flashing lamp, a wishbone, a wheel brake cylinder, or another car part, we can help you! Our “quick search” will assist you in our online store! We have a wide range of high quality products.

HOW TO DETECT MALFUNCTIONS OF THE ENGINE CYLINDER BLOCK

First, the engine should be diagnosed with a computer. This will allow checking the correctness of the engine operation cycle in the context of strokes, and the condition of pistons.

For a more thorough check, the engine should be removed from the vehicle. Dismantling the engine is a long and laborious process that requires a lot of knowledge and experience, therefore, it is recommended to entrust it to specialists at a service station.

After removing the Engine Block and dismantling its head and pistons, the component should be checked for damages inside.

The engine cylinder block service life is not limited to a certain duration. In most cases, replacement is not required during the entire service life of the vehicle. However, if the engine is operated incorrectly or foreign objects have got into the engine cylinder block, the component should be replaced. Poor quality lubricants and fuel cause clogging of the component.